Today was on a ride through NH, after fueling and starting back up my ABS and hazard light would not stop flashing. I checked all my bulbs and replaced one that may have been burned out but this did not help.
When I push down on my ABS switch both lights go solid.
Can you tell me what to do from here. It is a 1992 K 100 RS – never had this problem. Both brake master cylinders were replaced this year, all fluids flushed and system bled.
Is there a way for me to reset? Brakes are working fine.
Disregard – all set I used the wire in the middle diagnostic slot /alligator clip to ground and ABS rocker switch on, ignition on for 8 to 20 seconds. It reset – I will see if this continues.
I think the problem was the rear bulb was kinda burned out, there was a slight glow. I replaced along with the brake light. I believe this may have freaked the system and the reset worked.
You must be logged in to reply to this topic.